The HPA-Chassis-Two is a custom purpose built chassis designed for the HPA-nxV201ps, HPA-nxV202ps amplifiers modules.

The HPA-nxv200 or the nxV300 series amplifier modules can also be used with the HPA-nxVPSU-One power supply board.

Please note if you wish to use the nxV300 module with the Chassis-Two, only one nxV300 module will fit into the Chassis-Two using the recommended heat sink. (Conrad MF20-75) This limits the use of the nxV300 module with the Chassis-Two as a mono block amplifier design.

The HPA-Chassis-Two has been entirely coated with a high quailty Dulux Mannex Black ripple finish powder coat. The back panel have pre-punched mounting holes for RCA, loudspeaker binding posts and IEC mains socket on the rear panel. The front panel has a mounting hole for a single 3mm LED or a mains switch of your choice.

The new chassis also comes with high quality shock absorbing aluminium trimmed feet as shown in the photo below and the chassis has ventilation slots top and bottom for the best cooling possible in this type of chassis.

The HPA-Chassis-2 also allows for as many as two 300VA toroidal power transformers and or a single smaller transformer can be installed as well.