The NXVPSU-1 power supply board is a high performance, low noise power supply that has been designed for use with the NXV200, NXV300 and NXV500 audio amplifier modules and is designed to function as more of a slimline mono block power supply board. This is to say it is designed to power one audio amplfier module only. However it does have two pairs of power outlets so two amplifier modules can be supplied if so desired.

The NXVPSU-1 comes fitted as standard with four high quality 6800uf 80 volt "Illinois Capacitor" Capacitors. Larger capacity, higher voltage capacitors maybe installed if kept within 35mm diameter and the height is restricted to within the chassis internal height. In fact we can supply the NXVPSU-One with 10,000uf 63 volt capacitors for those that would like a little more storage albeit at a lower voltage rating of 63v. This would make it suitable for the HPA-nxV200 modules only. or other modules of your choice that require 55 volts or less to operate.

The NXVPSU-One is also suitable for use with any other amplifier modules available on the open market.

The NXVPSU-One is available as fully fitted out power supply ready to use or you can purchase it as a short form board without the main filter capacitors. This allows your choice of main filter capacitors, provided they are 10mm standard pitch snap in types and have a maximum diameter of 35mm.

       Key features include:

• The main bridge rectifier is contructed from,

• 60 Amp 200 volt ultra fast soft recovery diodes.

• Dual protection fuses before main rectifiers.

• Can be fitted with up to 60,000uf+ Total Capacitance.

• Quick spade connections for input and outputs.

• Total of 2 x fused DC supply rail outputs.

• Bleed down resistors across each supply rail.

• Auxiliary AC voltage power points to power loudspeaker protection units and power supply surge limiters.